Length: 29-31.5mm (Outer Wheel To Wheel Length With Axle Extended). Optional: Lower car’s ride height by sanding down the interior that holds the axles. Feed axle tube with wheel on it through car’s base.
Continue readingLowering Base 3D Printed For 1/64 Scale Hot Wheel Chevy Blazer 73 Custom
Modeled And Printed By Evolved Rides.
Continue reading10 Spoke Staggered Real Rider Wheels Rubber Tire For 1/64 Scale Hot
(1 Set Includes 4 Wheels, 4 Tires, 2 Fixed Axles. Optional: Lower car’s ride height by sanding down the interior that holds the axles. 1) Use a 1/8th Drill Bit to remove the rivet head on base of car/truck.
Continue readingLowering Base Frame 3D Printed For 1/64 Scale M2 Machines Chevy Trucks & Blazer
Vehicle/Wheels/Screws NOT Included with 3D Printed Base. Easy Base Swap, NO need to Grind/Cut Casting. Modeled And Printed By Evolved Rides.
Continue readingLowering Base 3D Printed For 1/64 Scale Hot Wheel 99 Ford F-150 SVT Lightning
Modeled And Printed By Evolved Rides. 11MM Wheels were used in the pictures above.
Continue reading1/64 Scale Rubber Tires For Real Rider Wheel 1/64 Scale Customs Restorations Hot
Slip new Tread on Wheels, Too prevent Axle from bending If its difficult to insert wheel into Tire use a Hair Dryer to heat up Tire for5-10 Seconds and it should slip on easy. 1 Set Of Tires (4 Matching Tires In Total).
Continue readingSteelie V2 Real Rider Wheels Rubber Tire For 1/64 Scale Custom Hot
Optional: Lower car’s ride height by sanding down the interior that holds the axles. -if the custom wheels don’t fit because axle is too short/long, you will need to adjust custom axle sets, see below.
Continue readingMoon Disc Smoothie Real Rider Wheels Rubber Tire For 1/64 Scale Hot
INCLUDED IS: 4 Wheels, 2 Fixed Axles, Plastic Storage Container. Optional: Lower car’s ride height by sanding down the interior that holds the axles. -if the custom wheels don’t fit because axle is too short/long, you will need to adjust custom axle sets, see below.
Continue reading8 Hole OFF-Road Real Rider Wheels Rubber Tire For 1/64 Scale Hot Custom
To Easily Install Tires on Wheels, use a Hair Dryer to heat up Tire for5-15 Seconds to make the Rubber Tire slightly squishy and slide onto Wheel. Tires are removable, you might receive Wheels Without Tires Pre-Installed (Instructions Bellow For Installing Tires On Wheels, Very easy).
Continue reading5 Spoke FUCHS Real Rider Wheels Rubber Tire For 1/64 Scale Hot
(1 Set Includes 4 Wheels, 4 Tires, 2 Fixed Axles. Optional: Lower car’s ride height by sanding down the interior that holds the axles. 1) Use a 1/8th Drill Bit to remove the rivet head on base of car/truck.
Continue reading