Item Tag: Display case rack shelf

Each one is custom made for you. Made of sturdy 0.25″ wood panel, framed on the back by approximately 1″ wide sturdy pine wood, has two hangers (50-pound capacity) mounted to be hung on 16″ center. Rails to hold cars are durable plastic. Cars shown in picture are for reference only. Measures approximately 23″ tall. Due to possible IP (Intellectual Property) rights, I have been asked to not name the manufacturers of the die cast collectable cars or to show pictures of. however, I will be glad to send you pictures or answer any questions you may have. Please note these are not designed for cars with thick plastic covers or cases. The lip of the strip is about 3/8″ wide (this is what covers one side of the card) and the thickness is about 3/16″, so any card thicker than that would not fit. All joints are glued using waterproof wood glue. Strips are hot glued on using Gorilla Hot Glue. Stronger angle joints are used on corners instead of weaker butt joints. Back brace is glued and screwed. Back of display is not painted. Each one is made to your specifications; they are available unfinished or in the color of your listed. Other colors may be available on a limited basis. Can also be built to hold other size cars upon request. (Please message me before ordering special sizes not listed.) Cars are NOT included! Tabletop Display:I am in the process of adding pictures of the Tabletop base model.Base legs will be the same color as the display.Each base leg will be approximately 5″.Base legs can be folding in if you are hanging the display.To save in shipping cost, base legs will not be installed.All necessary hardware and simple instructions are included (2 base legs, bolt, washers, nut, instructions)Hole is predrilled. PLEASE READ!When possible, I combine shipping, and use UPS or USPS. Any shipping cost you overpay will be refunded. Plese allow up to 7 business days to custom build your display.